Install guide

14
Step 5 – Configure the switch
This page displays if you are setting up the SG560, SG565 or SG580. If
you are setting up a different model, skip to “Step 6 – Confirm settings;
connect the SG unit to your LAN” on page 15.
By default, the SG unit's switch A behaves as a conventional switching
hub. However, it may be configured so that each port behaves as if it
were physically separate from the others.
1 Select a configuration for the SG unit's switch.
.
– If you require multiple network segments, such as a DMZ, guest
network, or second LAN; or if you want to use multiple
broadband Internet connections for Internet load balancing or
Internet failover, select 1 LAN Port, 3 Isolated Ports. Port A1 is
used as the primary LAN connection.
Note: Setting up multiple network segments and Internet connections is
not covered by this quick install guide. For further instructions, refer to
the SnapGear Administration Guide.
– Otherwise, select 4 LAN Ports.
2 Click Next. The Confirm Settings page appears.