User manual
Getting Started
38
User name: root
Password: default
Note
If you are unable to connect to the Management Console at 192.168.0.1, or the initial
username and password are not accepted, press the Reset button on the CyberGuard
SG appliance’s rear panel twice, wait 20 – 30 seconds, and try again. Pressing this
button twice within two seconds returns the CyberGuard SG appliance to its factory
default settings.
Enter and confirm a password for your CyberGuard SG appliance. This is the password
for the user root, the main administrative user account on the CyberGuard SG appliance.
It is therefore important that you choose a password that is hard to guess, and keep it
safe.
The new password takes effect immediately; you are prompted to enter it upon
completing the next step.
Note
The purpose of this step is to configure the IP address for the web management console.
For convenience, this is generally a free IP address on your LAN.
Locate the Bridge interface and select the Edit icon.
If your LAN has an active DHCP server, you may set up your CyberGuard SG appliance
and PC for auto-configuration. Otherwise you must manually set up your CyberGuard
SG appliance’s and PC’s network settings.