User manual

Getting Started
24
• Subnet mask is the subnet mask of the CyberGuard SG appliance’s LAN
connection.
• Default gateway is the IP address of the CyberGuard SG appliance’s LAN
connection.
• Preferred DNS server is the IP address of the CyberGuard SG appliance’s LAN
connection.
Click OK (or in 95/98/Me, Add then OK, reboot the PC if prompted to do so).
Perform these steps for each PC on your network.
Quick setup is now complete.
CyberGuard SG Rack Mount Appliance Quick Setup
Set up a PC to connect to the web management console
The CyberGuard SG appliance ships with initial, static IP settings of:
IP address: 192.168.0.1
Subnet mask: 255.255.255.0
Note
Initial configuration is performed through a port on network switch A (A1 – A4). All other
interfaces are by default inactive, i.e. there are no network services such as DHCP in
operation, and no IP address is configured.
If you attach A1 – A4 directly to a LAN with an existing DHCP server, or a PC running a
DHCP service, before performing the initial setup steps described below, it automatically
obtains an additional address. Your CyberGuard SG appliance is still reachable at
192.168.0.1.
The address you use when navigating to the unit (as described Set up the CyberGuard
SG appliance's password and LAN connection settings) is used as the CyberGuard SG
unit’s LAN interface address and the other is discarded.