User manual

Getting Started

•

You do not want to use a DHCP server, you will configure each host on the LAN

manually – proceed to Manual configuration of your LAN.

Automatic configuration of your LAN

By selecting Manual Configuration for the CyberGuard SG appliance’s LAN connection,

and supplying DHCP Server Address Range, you have already enabled and configured

the CyberGuard SG appliance’s DHCP server.

Each PC on your LAN must now be set up to use DHCP.

An example is given below for setting a Windows PC for automatic configuration:

Click Start -> (Settings ->) Control Panel and double click Network Connections (or

in 95/98/Me, double click Network).

If presented with multiple connections, right click on Local Area Connection (or

appropriate network connection) and select Properties.

Select Internet Protocol (TCP/IP) and click Properties (or in 95/98/Me, TCP/IP ->

[your network card name] if there are multiple entries) and click Properties (in

95/98/Me, you may also have to click the IP Address tab).