User manual

Getting Started
19
Set up the CyberGuard SG appliance’s switch
Note
This page only displays if you are setting up the SG560, SG565 or SG580. Otherwise
skip to Set up the PCs on your LAN to Access the Internet.
By default, the CyberGuard SG appliance’s switch A behaves as a conventional
switching hub. However, it may be configured so that each port behaves as if it were
physically separate from the others.
Select a configuration for the CyberGuard SG appliance’s switch, then click Next.
Select 1 LAN Port, 3 Isolated Ports if you want to have multiple network segments,
such as a DMZ, guest network or second LAN, or if you want to use multiple broadband
Internet connections for Internet load balancing or Internet failover. Port A1 is used as
the LAN port.
Note
For instructions on setting up multiple network segments, refer to the chapter entitled
Network Connections.