User manual

Getting Started

Default gateway: 192.168.0.1

Select Use the following DNS server addresses and enter:

Preferred DNS server: 192.168.0.1

Note

If you wish to retain your existing IP settings for this network connection, click Advanced

and Add the secondary IP address of 192.168.0.100, subnet mask 255.255.255.0.

Set up the password and LAN connection settings

Launch your web browser and navigate to 192.168.0.1.

Select Quick Setup Wizard from the center of the page.

A log in prompt is displayed. Enter the initial user name and password for your

CyberGuard SG appliance:

User name: root

Password: default

Note

If you are unable to connect to the web management console at 192.168.0.1, or the initial

username and password are not accepted, press the black Reset/Erase button on the

CyberGuard SG appliance’s rear panel twice, wait 20 – 30 seconds, and try again.

Pressing Reset/Erase twice within 2 seconds returns the CyberGuard SG appliance to its

factory default settings.