User manual

Network Setup
114
If you wish to secure the network share with a username and password
(recommended), click Add and type the user name the account to be used by the
CyberGuard SG appliance and click Check Names then OK.
Select this account, or Everyone if you are not securing the network share with a
username and password, and check Allow next to Full Control. Click OK and OK
again to finish.
• Set the CyberGuard SG appliance to use the network share
Under the Network Share tab, check Use share. Enter the location of the network
share in the format:
\\HOSTNAME\sharename
Enter the maximum size for the cache in Cache size.
Warning
Cache size should not be more than 90% of the space available to the network share,
e.g. if you shared a drive with 1 gigabyte of available storage, specify a Cache size of
900 megabytes.
Enter the Username and Password for a user that can read and write to the network
share. If you allowed Full Control to Everyone, you may leave these blank.