Specifications

Chapter 4 - MGCP Protocol Features Basic Information
66
Mediatrix 4100
Basic Information
You can set general MGCP information pertaining to the Mediatrix 4100. This information is located in the
mgcpMIBObjects group of the mgcpMIB.
 To set basic MGCP information:
1. Set the UDP port number on which the Mediatrix 4100 is listening for any MGCP request in the
mgcpPort variable.
The default value is 2427.
2. Set the default digit map for all the endpoints in the mgcpDefaultDigitMap variable.
This digit map is used if no digit map is sent by the Call Agent. The default value is x.T.
3. Define the level of restart for initial RSIP (Restart in Progress) in the mgcpRestartLevel variable.
The RSIP command is used by the gateway to signal that an endpoint, or a group of endpoints, is
put in-service or out-of-service.
The default value is gateway.
4. Indicate if the EndpointIdList returned by a wildcarded AUEP (audited endpoint) will include or not
endpoints that are not started in the mgcpEndpointIdListIncludeNotStarted variable.
The following values are available:
• excludeNotStarted(0)
• includeNotStarted(1)
The default value is excludeNotStarted.
5. Indicate if piggy-backing can be used to send several MGCP messages in the same UDP packet in
the mgcpPiggyBackingEnable variable.
The following values are available:
• disable(0)
• enable(1)
The default value is enable.
6. Specify if the ptime is included in the SDP packets in the mgcpAddPtimeIfPresentInLCO variable.
The following values are available:
• excludePtime(0)
• includePtime(1)
In the Unit Manager Network Administration Manual, refer to chapter Signalling Protocols Parameters, section
MGCP Configuration Window.
Table 49: RSIP Level
Level Example
gateway(0) RSIP 45531023 *@[192.168.13.60]
group(1) RSIP 45531023 aaln/*@[192.168.13.60]
RSIP 45531023 aalg/*@[192.168.13.60]
endpoint(2) RSIP 45531023 aaln/1@[192.168.13.60]
RSIP 45531023 aaln/2@[192.168.13.60]
RSIP 45531023 aalg/3@[192.168.13.60]
RSIP 45531023 aalg/4@[192.168.13.60]