Specifications

Chapter 3 - IP Address and Network Configuration Services
48
Mediatrix 4100
Management Server
The ipAddressConfigMs group provides the configuration necessary for contacting a SNMP management
server such as the Media5 Unit Manager Network.
 To select the Management Server configuration source:
1. In the ipAddressConfig folder, locate the msSelectConfigSource variable (under the
ipAddressConfigMs group).
2. Set this variable to either static or dhcp (vendor/site specific option).
3. Restart the Mediatrix 4100 so that the changes may take effect.
Configuration File Fetching
The ipAddressConfigFileFetching group provides the configuration necessary to contact the configuration file
server when fetching a configuration file.
 To select the configuration file fetching server configuration source:
1. In the ipAddressConfig folder, locate the configFileFetchingSelectConfigSource variable (under the
ipAddressConfigFileFetching group).
2. Set this variable to either static or dhcp (vendor/site specific option).
In the Unit Manager Network Administration Manual, refer to chapter Administration Parameters, section Unit
Manager Server.
Table 32: Management Server Source
Variable Default Static Value DHCP Source
msHost N/A Use option specified in variable
msDhcpSiteSpecificCode, bytes 0-3.
If not specified (0), use option 43, sub-option
200, bytes 0-3.
msStaticHost “192.168.0.10” N/A
msTrapPort N/A Use option specified in variable
msDhcpSiteSpecificCode, bytes 4-5.
If not specified (0), use option 43, sub-option
200, bytes 4-5. If bytes 4-5 are not present, use
the default static value.
msStaticPort 162 N/A
msStaticTrapPort 162 N/A
Note: If you change the value of the msStaticTrapPort variable, change the port used in the management
server. Not doing so will prevent you from viewing the received traps from the unit.
Table 33: Configuration File Fetching Source
Variable Default Static Value DHCP Source
configFileFetching
Host
N/A Use option specified in variable
configFileFetchingDhcpSiteSpecificCode, bytes
0-3.
If not specified (0), use option 43, sub-option
201, bytes 0-3.