Specifications

Chapter 1 - Installation Choosing a Suitable Installation Site

Mediatrix 4100

Rear Connectors

The Mediatrix 4100 has several connections that must be properly set. Figure 5 shows the back panel of the

Mediatrix 4100.

Figure 5: Back Panel Connector

Table 5 describes the back panel connections.

Choosing a Suitable Installation Site

The Mediatrix 4100 is suitable for use in an office environment where it can be placed in the same room or

cabinet where the PBX/telephony equipment is located. The unit can be mounted on a standard 48.26 cm (19

in.) equipment rack.

Location

Install the Mediatrix 4100 in a well-ventilated location where it will not be exposed to high temperature or

humidity. Do not install the Mediatrix 4100 in a location exposed to direct sunlight or near stoves or radiators.

Excessive heat could damage the internal components.

When deciding where to position the Mediatrix 4100, ensure that:

 The Mediatrix 4100 is accessible and cables can be easily connected.

 The cabling is away from the following:

• Sources of electrical noise such as radios, transmitters, and broadband amplifiers.

• Power lines and fluorescent lighting fixtures.

• Water or moisture that could enter the casing of the Mediatrix 4100.

 The airflow is not restricted around the Mediatrix 4100 or through the vents in the side and back

of the unit. The unit requires a minimum of 25 mm (1 in.) clearance.

 The fan on the Mediatrix 4100 is not blocked or that the back of the unit is not too close to the

wall.

Table 5: Back Connections of the Mediatrix 4100

Connection Description

Power connector IEC320-C14 Power Cord Receptacle. This power cord supplies an internal

Switching Mode Power Supply (SMPS) Universal input. The power supply range

is 100 – 240 VAC; 50/60 Hz; 1.6 A.

Rack-mounting

bracket

Universal Power Supply Unit

Warning: The analog lines of the Mediatrix 4100 are not intended for connection to a telecommunication

network that uses outside cable.

Warning: To prevent fire or shock hazard do not expose the unit to rain or moisture.