Specifications

Mediatrix 4100 3
C HAPTER
1
Installation
This chapter describes the installation and initial provisioning of the Mediatrix 4100.
Requirements
The Mediatrix 4100 requires the following items to work properly:
Safety Recommendations
To ensure general safety, follow these guidelines:
 Do not open or disassemble the Mediatrix 4100.
 Do not get the Mediatrix 4100 wet or pour liquids into it.
 Do not perform any action that creates a potential hazard to people or makes the equipment
unsafe.
Package Contents
The Mediatrix 4100 package contains the following items:
 the Mediatrix 4100 unit
 two rack-mounting brackets
 a power cord for the country in which you are using the Mediatrix 4100
 a printed Flyer
You also need a 10/100 BaseT Ethernet RJ-45 cable.
Table 3: Required Items
Item Description
Analog lines (Mediatrix
4124 only)
Standard analog lines wired into a RJ21X cable. This cable may be directly
connected to the Key Service Unit (KSU) or PBX Main Distribution Frame. See
“
RJ21X Connector (Mediatrix 4124)” on page 203 for more details.
DHCP Server (optional) Supplies network parameters to the Mediatrix 4100.
DNS Server (optional) Translates domain names into IP addresses.
Call Agent Manages the active calls of the Mediatrix 4100.
Management Server
(optional)
Module or software used to remotely manage and configure the Mediatrix 4100.
Such software could be the Media5 Unit Manager Network. See “
Unit Manager
Network – Element Management System” on page xvii for more details.
TFTP Server or HTTP
Server
Necessary for software updates.
Syslog Daemon
(optional)
Receives all status messages coming from the Mediatrix 4100.