Specifications

Compatibility Version Reference Manual (MGCP/NCS Version)

Mediatrix 4100

Compatibility Version

You can define the content of the Protocol header in a packet.

 To set the compatibility version:

1. In the ncsCompatibilityMIB, under mediatrixExperimental, locate the ncsCompatibilityMIBObjects

group.

2. Set the ncsCompatibilityVersion variable.

Interoperability Configuration

Please refer to “Interoperability Configuration” on page 79 for a few interoperability parameters you can use

to impove the way the Mediatrix 4100 interops with other products.

Table 72: NCS Compatibility Version Parameters

Parameter Description

mgcp01Ncs10 The Protocol header is set to 'MGCP 0.1 NCS 1.0'. This protocol is

fully supported.

fakeMgcp10Ncs10 The Protocol header is set to 'MGCP 1.0 NCS 1.0'. This protocol is

not supported and the behavior of the unit is the same as for MGCP

0.1 NCS 1.0. This is a fake support to allow communication with a call

agent that supports it.

This configuration only has an effect if the

telephonyIpSignalingProtocolSelection variable is set to ncs

(“

Introduction” on page 85).

Note: The interoperability parameters apply to units that are either running the MGCP os NCS signalling

protocol.