Specifications

Chapter 5 - NCS Protocol Features Endpoints
88
Mediatrix 4100
The default value is gateway.
4. Indicate if the EndpointIdList returned by a wildcarded AUEP (audited endpoint) will include or not
endpoints that are not started in the ncsEndpointIdListIncludeNotStarted variable.
The following values are available:
• excludeNotStarted(0)
• includeNotStarted(1)
The default value is excludeNotStarted.
5. Indicate if piggy-backing can be used to send several NCS messages in the same UDP packet in
the ncsPiggyBackingEnable variable.
The following values are available:
• disable(0)
• enable(1)
The default value is enable.
6. Restart the Mediatrix 4100 so that the changes may take effect.
Endpoints
Endpoints are originating or terminating devices such as phones or faxes. This table contains the local
endpoint name. The endpoint name is created as follows: term2/term1@localHostFqdn.
 To set endpoints information:
1. In the ncsMIB, locate the ncsEndpointIfTable group.
This group contains the endpoint information to set.
2. Set the following variables:
3. Restart the Mediatrix 4100 so that the changes may take effect.
endpoint(2) RSIP 45531023 aaln/1@[192.168.13.60]
RSIP 45531023 aaln/2@[192.168.13.60]
RSIP 45531023 aalg/3@[192.168.13.60]
RSIP 45531023 aalg/4@[192.168.13.60]
Table 68: RSIP Level (Continued)
Level Example
In the Unit Manager Network Administration Manual, refer to chapter Signalling Protocols Parameters, section
NCS Configuration Window.
Table 69: NCS Endpoint Information
Variable Description
ncsEndpointIdTerm1 The rightmost term of the local endpoint name.
ncsEndpointIdTerm2 Second term from the right of the local endpoint name.
Default Value: aaln