Specifications

Basic Information Reference Manual (MGCP/NCS Version)
Mediatrix 4100
87
Static Configuration
Use the static configuration if you are not using a DHCP server or if you want to bypass it.
 To use static information:
1. In the ipAddressConfig folder, locate the ncsCASelectConfig Source variable (under the
ipAddressConfigNcsCallAgent group).
This variable defines whether the Mediatrix 4100 shall ask for its Call Agent settings through a
DHCP server or not.
2. Set the ncsCASelectConfigSource variable to static.
3. Set the following variables:
4. Restart the Mediatrix 4100 so that the changes may take effect.
Basic Information
You can set general NCS information pertaining to the Mediatrix 4100. This information is located in the
ncsMIBObjects group of the ncsMIB.
 To set basic NCS information:
1. Set the UDP port number on which the Mediatrix 4100 is listening for any NCS request in the
ncsPort variable.
The default value is 2427.
2. Set the default digit map for all the endpoints in the ncsDefaultDigitMap variable.
This digit map is used if no digit map is sent by the Call Agent. The default value is x.T.
3. Define the level of restart for initial RSIP (Restart in Progress) in the ncsRestartLevel variable.
The RSIP command is used by the gateway to signal that an endpoint, or a group of endpoints, is
put in-service or out-of-service.
Table 67: NCS Call Agent Static Address
Variable Description
ncsCAStaticHost Static NCS Call Agent IP address or domain name.
Default Value: 192.168.0.10
ncsCAStaticPort Static NCS Call Agent IP port number.
Default Value: 2727
In the Unit Manager Network Administration Manual, refer to chapter Signalling Protocols Parameters, section
NCS Configuration Window.
Table 68: RSIP Level
Level Example
gateway(0) RSIP 45531023 *@[192.168.13.60]
group(1) RSIP 45531023 aaln/*@[192.168.13.60]
RSIP 45531023 aalg/*@[192.168.13.60]