User manual

Network Connections
48
3. Network Connections
This chapter describes the Network Setup section of the Web Management Console.
Here you can configure each of your CyberGuard SG appliance’s network ports
(Ethernet, serial). Network ports may be configured for Internet connection, LAN
connection, DMZ connection, remote dialin access or Internet failover.
If you are using a CyberGuard SG gateway or rack mount appliance, the section Set up
the PCs on your LAN to access the Internet in the chapter entitled Getting Started
describes how to configure the PCs on your LAN to share the connection once your
Internet connection has been established.
Connections
Under the Connections tab, each of the network ports of your CyberGuard SG appliance
is displayed alongside its Device Name and current Configuration. Initially, all network
ports will be unconfigured, aside from LAN (Port A on the SG710 and SG710+).
A network port can be configured for a different function by selecting a new configuration
from the Configuration pull down menu.
Figure 3-1
The current configuration can be viewed or modified by selecting Edit current settings.
Selecting Remove this network configuration unconfigures a network port (you will be
prompted to confirm this action).