User manual

Getting Started
32
It is recommended that you statically configure your CyberGuard SG appliance’s LAN
connection settings rather than rely on an existing DHCP server.
Enter an IP address and Netmask for your CyberGuard SG appliance’s LAN connection.
You may choose to use the CyberGuard SG appliance’s initial network settings if you are
sure no other PC or network device already has the address of 192.168.0.1.
Figure 2-10
The IP address will later be used as the gateway address for the PCs on your LAN.
Take note of this IP address and subnet mask, as you will need them later on.
Note
You may leave Gateway Address and DNS Server(s) blank at this point.
Otherwise, check DHCP assigned (not generally recommended) if you have an existing
DHCP server that you wish to have automatically configure your CyberGuard SG
appliance’s LAN connection settings.
Click Apply then Network Setup from the Networking menu.