User manual

Getting Started
28
Note
It is recommended that you perform the initial setup steps with the CyberGuard SG
appliance connected to a single PC only. However, you may choose to connect the
CyberGuard SG appliance to the LAN before completing the initial setup steps.
Before doing so, it is critical that you ensure there are no other devices on the LAN
with an address of 192.168.0.1
Use the straight through cable (blue) to connect the CyberGuard SG appliance to your
LAN’s hub.
Next, you must modify your PC’s network settings to enable it to communicate with the
CyberGuard SG appliance.
Click Start -> Settings -> Control Panel and double click Network Connections (or in
95/98/Me, double click Network).
Right click on Local Area Connection and select Properties.
Note
If there is more than one existing network connection, select the one corresponding to the
network interface card to which the CyberGuard SG appliance is directly attached.
Select Internet Protocol (TCP/IP) and click Properties (or in 95/98/Me, TCP/IP ->
your network card name if there are multiple entries) and click Properties.