User manual

Getting Started
13
2. Getting Started
This chapter provides step-by-step instructions for installing your CyberGuard SG
appliance into your network and connecting to the Internet. This is a slightly more
detailed version of the printed Quick Install Guide that shipped with your CyberGuard SG
appliance.
These instructions assume you have a PC running Microsoft Windows (95/98/Me/
2000/XP for CyberGuard SG gateway and rack mount appliances, 2000/XP only for
CyberGuard SG PCI appliances). If you are installing a CyberGuard SG gateway or rack
mount appliance, you must have an Ethernet network interface card installed. You may
need to be logged in with administrator privileges.
Instructions are not given for other operating systems – refer to your operating system
documentation on how to configure your PCs’ network settings using the examples given
for Windows PCs as a guide.
• If you are setting up a CyberGuard SG gateway appliance (SG300, SG530, SG550,
SG570, SG575) proceed to CyberGuard SG gateway appliances.
• If you are setting up a CyberGuard SG rack mount appliance (SG710, SG710+)
proceed to CyberGuard SG rack mount appliances.
• If you are setting up a CyberGuard SG PCI appliance (PCI630, PCI635), proceed to
CyberGuard SG PCI appliances.
Note
Installing your CyberGuard SG appliance into a well-planned network is easy. However,
network planning is outside the scope of this manual. Please take the time to plan your
network before installing your CyberGuard SG appliance.