Installation guide

8
Step 4 — Set up the SG unit's password and LAN connec-
tion settings
a. Launch your Web browser and navigate to 192.168.0.1.
Note: If you are unable to browse to the SG unit at 192.168.0.1, or the
initial username and password are not accepted, press the erase button on
the SG unit's rear panel twice within 3 seconds, 1 second apart. Wait 20 -
30 seconds, and then try browsing to 192.168.0.1 again. Pressing erase as
instructed resets the SG unit to its factory default settings.
The SnapGear Management Console page appears:
.
b. Click the Quick Setup Wizard link in the center of the page.
DESK_BODY.fm Page 8 Thursday, June 14, 2007 8:29 AM