Installation guide

Step 1 — Unpack the SG unit

In addition to this document, check that you have the following items

included with your SG unit:

 Power cable

 Power adaptor

 SG CD

 Network cable

Take a few minutes to get familiar with the SG unit. On the rear panel of the

SG unit, there are network, serial, and possibly USB ports, an erase button,

and a power inlet.

The front panel of the SG unit contains activity LEDs (lights) that vary

slightly between models.The status LEDs provide information on the

operating status of the SG unit.

Step 2 — Power on the SG unit

Connect the power adapter to the SG unit and apply power. Use only the

power adapter packaged with the unit.

Check the front panel lights:

• System/Heart Beat (H/B) /TST flashes when the SG unit is running.

• Initially, all appliance models except for the SG300 also have all other

front panel LEDs flashing.

Note: If these LEDs do not behave in the above manner before your SG

unit is attached to the network, perform a factory reset. Press the erase

button on rear panel twice within three seconds, 1 second apart to restore

factory default settings. If the LEDs are still not flashing after 30 seconds,

you may need to contact customer support.

DESK_BODY.fm Page 5 Thursday, June 14, 2007 8:29 AM