Specifications

Configuring the Components

Server Procedure 930335A CyberData Corporation

5.0 Configuring the Components

5.1 V2 Ceiling Speaker

Install the ceiling speaker in the appropriate location following the instructions, and connect a PoE-

enabled Ethernet network cable to the device and plug it into your voice or main network. The

Status light should be green. Now use a paperclip or similar device to press and briefly hold the

RTFM button on the front of the speaker. The speaker will read aloud the IP address of the device. If

it does not do so then it is not properly plugged into a network with DHCP using a PoE-enabled

switch and cable.

5.1.1 On a computer connected to the same network, open a web browser and go to the address

that was read aloud by the speaker.

5.1.2 You should be prompted for a password. The default username and password are both

admin.

5.1.3 If you wish you can change the password on the initial screen.

5.1.4 There are tabs on the left for the various device configuration options:

• Device Config – controls various optional behavior aspects of the speaker. Most are

self-explanatory or see the user manual for further info. These settings can be left

defaulted for basic operations.

• Networking – control how the device connects to the network. For most users this can

be left as defaulted for DHCP. If desired the network settings can be changed.

• Sip Config – configures how the speaker should connect to a SIP account. If you are

using this speaker as a unit with the paging server, you must:

5.1.4.1 Uncheck the ‘Enable SIP operation’ box and press Save at the bottom.

5.1.4.2 Press the Reboot button.

Note If you are using this speaker as a standalone extension, connecting to your

RingCentral account without using the paging server, then you will input your

SIP account settings here.

5.1.4.3 In the ‘SIP Server’ field enter the value from your RC account labeled ‘SIP

Domain’ but leave off the ‘:5060’, so it should be ‘sip.ringcentral.com’.

5.1.4.4 In the ‘Remote SIP Port’ field enter 5060.

5.1.4.5 In the ‘Local SIP Port’ field enter 5060.

5.1.4.6 In the ‘Outbound Proxy’ field enter the value from your RC account labeled

‘Outbound Proxy’ but leave off the ‘:5090’ part, so just ‘sip.ringcentral.com’.

5.1.4.7 In the ‘Outbound Proxy Port’ field enter 5090.

5.1.4.8 In the ‘SIP User ID’ field enter the value from your RC account labeled ‘User

Name’.

5.1.4.9 In the ‘Authenticate ID’ field enter the value from your RC account labeled