Product specifications

Installing the VoIP Paging Amplifier

Configure the Paging Amplifier Parameters

VoIP Paging Amplifier Operations Guide 930185B CyberData Corporation

2.3 Configure the Paging Amplifier Parameters

To configure the Paging Amplifier online, use a standard web browser.

Configure each Paging Amplifier and verify its operation before you mount it. When you are ready

to mount a Paging Amplifier enclosure, refer to

Appendix A, “Mounting the Amplifier” for instructions.

All Paging Amplifier are initially configured with the default IP settings indicated in Table 2-7.

When configuring more than one Paging Amplifier, attach the Paging Amplifiers to the network one

at a time to avoid IP address conflicts.

2.3.1 Log in to the Configuration Home Page

1. Open your browser to the speaker IP address.

For the initial configuration of the speaker, open your browser to the default IP address:

http://192.168.3.10

Note Make sure that the PC is on the same IP network as the Paging Amplifier.

2. When prompted, use the following default Web Access Username and Web Access Password

to access the Home Page (Figure 2-11):

Web Access Username: admin

Web Access Password: admin

Table 2-7. Factory Default Settings

Parameter Factory Default Setting

IP Addressing static

IP Address 192.168.3.10

Web Access Username admin

Web Access Password admin

Subnet Mask 255.255.255.0

Default Gateway 192.168.3.1