Product specifications

Installing the VoIP Intercom

Configure the Intercom Parameters

Operations Guide 930242F CyberData Corporation

3. After changing the parameters, click Save Settings.

Authenticate ID* Enter the Authenticate ID (up to 25 alphanumeric

characters).

Authenticate Password* Enter the Authenticate Password (up to 25 alphanumeric

characters).

SIP Registration* Enable/Disable SIP Registration.

For information about the Point-to-Point Configuration, see

Section 2.1.4.1, "Point-to-Point Configuration".

minutes).

Dial-Out Extension Enter the button dial-out extension number.

The Dial Out Extension also supports the addition of

comma delimited pauses before sending additional DTMF

tones (using rfc2833). The first comma will pause three

seconds after a call is first established with a remote

device. Subsequent commas will pause for two seconds. A

pause of one second will be sent after each numerical digit.

Examples of Dial-Out Extension strings:

302: Dial out extension 302 and establish a call.

302,2: Dial out extension 302 and establish a call. Wait

three seconds and then send the DTMF tone '2'.

302,25,,,4,,1: Dial out extension 302 and establish a call.

Wait 3 seconds and then send the DTMF tone '2'. Send out

DTMF tone 5. Wait six seconds. Send out DTMF tone 4.

Wait four seconds. Send out DTMF tone 1.

Note: The maximum number of total characters in the dial-

out field is 25.

Click this button to save your configuration settings.

Changing a parameter that has an asterisk next to it will

cause a system reboot when saved.

Link to the Intercom Setup page.

Link to the Network Setup page.

Link to the Upgrade Firmware page.

Link to the Home page.

Table 2-7. SIP Setup Parameters (continued)

Web Page Item Description