Product specifications

Installing the VoIP Intercom
Intercom Setup
Operations Guide 930242F CyberData Corporation
17
2.1.6.2 Restore the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Each Intercom is delivered with factory set default values. Use the RTFM switch on the Intercom
face to restore these parameters to the factory default settings.
To restore the factory default settings:
1. Complete steps 1 through 4 in Section 2.1.6.1, "Announcing the IP Address".
2. Press and hold the Call button for 10 seconds.
3. When you hear the announcement, release the Call button. The factory default settings are
restored, and the Intercom will automatically restart.
4. After the Intercom has rebooted, remove the jumper from JP11.
5. Cycle power by disconnecting the PoE cable from J1 and plugging the PoE cable back into J1.
Figure 2-16. RTFM Switch Jumper
2.1.7 Adjust the Volume
You will be only able to adjust the volume through the network configuration page.