Product specifications

VoIP Paging Gateway Operations Guide 930098E CyberData Corporation
2.4.5 Broadcast a Test Message to a Specific Paging Zone
Once the VoIP Paging Gateway is set up and configured, you can broadcast test messages to
different paging zones that you specify. On the Home page, click Gateway Setup to open the
Gateway Configuration page.
Note You can broadcast a test message to all paging zones by using the Test/Reset switch on the
back of the VoIP Paging Gateway. See
Section 2.3.5, "Broadcast a test message to all paging
zones" for instructions.
Figure 2-10. Gateway Configuration Page
To broadcast a test message to a specific paging zone, complete the following steps:
1. Enter the paging Zone you want to test.
2. Click Audio Test. The VoIP Paging Gateway sends a brief audio message to that zone. Notice
that the round, green Paging light below the Status light blinks when a page is in progress