Product specifications

VoIP Paging Gateway Operations Guide 930098E CyberData Corporation
4. On the Network Setup page, enter values for the parameters indicated in Table 2-2.
On this page, complete the following steps:
1. Specify whether you use Static or DHCP IP Addressing by marking the appropriate radio
button. Then, if you select Static, go to
Step 2.
Note Changing the IP Addressing selection causes the system to reboot after you select Save
Settings.
2. For Static IP Addressing, also enter values for the following parameters:
a. The VoIP Paging Gateway’s IP Address: The VoIP Paging Gateway is delivered with a
factory default IP address. Change the default address to the correct IP address for your
system.
Note Changing the VoIP Paging Gateway’s IP Address causes the system to reboot after you select
Save Settings.
b. The Subnet Mask.
c. The Default Gateway.
3. Click Save Settings when you are finished.
Table 2-2. Network Setup Parameters
Web Page Item Description
IP Addressing* Select either DHCP IP Addressing or Static IP Addressing by
marking the appropriate radio button. If you select Static, configure
the remaining parameters indicated in
Table 2-2. If you select DHCP,
go to Step 3.
IP Address* Enter the Static IP address.
Subnet Mask Enter the Subnet Mask address.
Default Gateway Enter the Default Gateway address.
DNS Server 1* Enter the DNS Server 1 address.
DNS Server 2* Enter the DNS Server 2 address.
Click on this button to save your configuration settings. Changing a
parameter that has an asterisk next to it will cause a system reboot
when saved.
Link to the Gateway Setup web page.
Link to the SIP Setup web page.
Link to the Upgrade Firmware web page.
Link to the Home page.