Product specifications

CyberData Corporation 930098C VoIP Paging Gateway Operations Guide
Implementing the VoIP Paging Gateway
16
On this page:
1. Specify whether you use Stat
ic or DHCP IP Addressing by marking the appropriate radio
button. Then, if you select Static, go to Step 2.
Note Cha
n
ging the IP Addressing selection causes the system to reboot when click Save Settings.
2. For Static IP Addressing, also enter values for the following parameters:
a. The VoIP Paging Gateway’s IP Address:
The V
oIP Paging Gateway is delivered with a
factory default IP address. Change the default address to the correct IP address for your
system.
Note Changing the V
oIP Paging Gateway’s IP Address causes the system to reboot when you
click Save Settings.
b. The Subnet Mask.
c.
The Default Gateway.
3.
Click Save Settings when
you finish.
2.4.4 Change the Default Username and Password
On the Home page, click Gateway Setup to open the Gateway Configuration page. After changing
the Username and Password on this page, new browser requests require you to log in using these
new parameters.
Note You can
also run an audio test from this page, as described in Section 2.4.5, "Broadcast a Test
Message to a Specific Paging Zone".
Link to the Upgrade Firmware web page.
Link to the Home page.
Table 2-2. Network Setup Parameters (continued)
Web Page Item Description
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]