Product specifications

CyberData Corporation 930098C VoIP Paging Gateway Operations Guide
Implementing the VoIP Paging Gateway
14
At this point you can:
● Review the VoIP Paging Gateway’s Current Settings. Use the Test/Reset switch toRestore the
Factory Default Settings as Required. Refer to page 10.
● Configure the network parameters. Click Network Setup and refer to Section 2.4.3, "Configure
the Network Parameters" for instructions.
● Configure the VoIP Paging Gateway parameters. Click Gateway Setup and refer to Section
2.4.4, "Change the Default Username and Password" for instructions.
● Configure the SIP parameters. Click SIP Setup and see Section 2.4.6, "Configure the SiP
Parameters".
Note Click the
Upgrade Firmware button any time you need to upload new versions of the
firmware or Reboot the VoIP Paging Gateway. Refer to Section 2.5, "Upgrading the
Firmware" and Section 2.6, "Rebooting the VoIP Paging Gateway" for instructions.
2.4.3 Configure the Network Parameters
Configuring the network parameters enables your network to recognize the VoIP Paging Gateway
and communicate with it. Click Network Setup on the Home page to open the Network
Configuration page.
IP Addressing Shows the current IP addressing setting (DHCP or static).
IP Address Shows the current IP address.
Subnet Mask Shows the current subnet mask address.
Default Gateway Shows the current default gateway address.
Link to the Network Setup web page.
Link to the Gateway Setup web page.
Link to the SIP Setup web page.
Link to the Upgrade Firmware web page.
Table 2-1. Home Page Overview
Web Page Item Description
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]