Product specifications

CyberData Corporation 930098C VoIP Paging Gateway Operations Guide
Implementing the VoIP Paging Gateway
6
2.3 Setting up the VoIP Paging Gateway
Before you set up the VoIP Paging Gateway, be sure that you have received all the parts described in
Section 2.1, "Parts list".
To set up the VoIP Paging Gateway:
● Connect to the Power Source
● Connect to the Network
● Confirm that the VoIP Paging Gateway is up and running
• Confirm Power on, Network Connectivity, and Baud Rate
• Verify Network Activity
● Connect to a Paging Device
• Connect the VoIP Paging Gateway to a Paging Amplifier
• Connect the VoIP Paging Gateway to a Telephone
● Broadcast a test message to all paging zones
● Restore the Factory Default Settings as Required
2.3.1 Connect to the Power Source
To use PoE, plug a Cat 5 Ethernet cable from the VoIP Paging Gateway Ethernet port to your
network. As an alternative to PoE, you can plug one end of a +48V DC power supply into the Paging
Gateway, and plug the other end into a receptacle. Connect the earth grounding wire to the chassis
ground on the back of the unit.
Figure 2-2. Connecting to the Power Source
48V DC
Chassis
ground
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]