Product specifications

Installing the VoIP V2 Speaker
Configure the Speaker Parameters
Operations Guide 930274R CyberData Corporation
26
2. On the Device Configuration page, you may enter values for the parameters indicated in
Ta b l e 2-6.
Web Page Item
Description
Volume Settings
Use Digital Volume Control When selected, you can bypass the analog volume knob on the front
of the speaker. The volume level will only be determined by the digital
Speaker Volume setting on the Device Configuration page.
Speaker Volume Type the desired speaker volume level into this field 
(1 character limit).
Volume Boost
When Volume Boost is enabled, the device will play at a higher
volume at the risk of having the audio clip at very high levels.
Relay Settings
Activate Relay with DTMF Code When selected, the relay can be activated with a DTMF code.
DTMF Activation Code Type the desired DTMF activation code (25 character limit).
DTMF Activation Duration (in
seconds)
Type the desired DTMF activation duration (in seconds) (2 character
limit [activation times now go up to 99 seconds]).
NOTE: A DTMF activation duration of 0 will toggle the relay indefinitely
or until the activation code is sent again
Activate Relay During Ring When selected, the relay will be activated for as long as the call is
a
ctive.
NOTE: When the phone is set to Auto Answer, it will not ring and this
option does nothing.
Activate Relay During Night Ring Check this box to activate the relay for as long as a Night Ring tone is
r
inging.
Activate Relay While Call Active
When selected, the relay will be activated for as long as the call is
active.
Miscellaneous Settings
Beep on Initialization When selected, you will hear a beep when the speaker initializes.
Auto-Answer Incoming Calls When selected, the device will automatica
lly answer incoming calls.
When Au
to Answer is Off, the device will play a ringtone through the
speaker.
Click the Sa
ve button to save your configuration settings.
Note: Y
ou need to reboot for changes to take effect.
Click on the Te
st Audio button to do an audio test. When the Test
Audio button is pressed, you will hear a voice message for testing the
device audio quality and volume.
Click on the T
est Relay button to do a relay test.
Click on the Rebo
ot button to reboot the system.
3. After changing the parameters, click the Save button.
Table 2-6. Device Configuration Parameters