Product specifications

Installing the VoIP V2 Speaker

Device Configuration

Operations Guide 930274R CyberData Corporation

2.2.3 Confirm that the Speaker is Operational and Linked to the Network

After connecting the speaker to the 802.3af compliant Ethernet hub, the LEDs on the speaker face

confirm that the speaker is operational and linked to the network.

Figure 2-8. Status and Activity LEDs

2.2.3.1 Status LED

After supplying power to the speaker:

1. The green power/status LED and the yellow network LED comes on immediately.

2. After about 23 seconds with a static IP address (or 27 seconds if the board is set to use DHCP),

the green LED will blink twice to indicate that the board is fully booted. The speaker will beep at

this time if the

Beep on Initialization option is enabled on the Device Configuration Page (see

Section 2.3.4, "Configure the Device Parameters").

Note If the board is set to use DHCP and there is not a DHCP server available on the network, it

will try 12 times with a three second delay between tries and eventually fall back to the

programmed static IP address (by default 10.10.10.10). This process will take approximately

80 seconds.

Note The front power/status LED will remain solid on during operation.

2.2.3.2 Link LED

•The Link LED is illuminated when the network link to the speaker is established.

•The Link LED blinks to indicate network traffic.

Speaker

Status

(Green)

Network 

Link/Activity

(Yellow)