Product specifications

Installing the VoIP V2 Speaker
Configure the Device Parameters
Operations Guide 930468A CyberData Corporation
30
2. On the Device Configuration page, you may enter values for the parameters indicated in
Table 2-6.
Table 2-6. Device Configuration Parameters
Web Page Item Description
Volume Settings
Use Digital Volume Control When selected, you can bypass the analog volume knob on the front
of the speaker. The volume level will only be determined by the digital
Speaker Volume setting on the Device Configuration page.
Speaker Volume Type the desired speaker volume level into this field
(1 character limit).
Volume Boost When Volume Boost is enabled, the device will play at a higher
volume at the risk of having the audio clip at very high levels.
Microphone Gain Type the desired microphone gain level into this field.
Relay Settings
Activate Relay with DTMF Code When selected, the relay can be activated with a DTMF code.
DTMF Activation Code Type the desired DTMF activation code (25 character limit).
DTMF Activation Duration (in
seconds)
Type the desired DTMF activation duration (in seconds) (2 character
limit [activation times now go up to 99 seconds]).
NOTE: A DTMF activation duration of 0 will toggle the relay indefinitely
or until the activation code is sent again
Activate Relay During Ring When selected, the relay will be activated for as long as the call is
active.
NOTE: When the phone is set to Auto Answer, it will not ring and this
option does nothing.
Activate Relay During Night Ring Check this box to activate the relay for as long as a Night Ring tone is
ringing.
Activate Relay While Call Active When selected, the relay will be activated for as long as the call is
active.
Activate Relay on Button Press When selected, the relay will be activated when the Call Button is
pressed.
Relay on Button Press Timeout
(in seconds)
Type the desired time (in seconds) that you want the relay to activate
after the Call Button is pressed (1 character limit).
Miscellaneous Settings
Beep on Initialization When selected, you will hear a beep when the speaker initializes.
Auto-Answer Incoming Calls When selected, the device will automatically answer incoming calls.
When Auto Answer is Off, the device will play a ringtone through the
speaker.
Button Lit When Idle When selected, the Call Button remains lit when idle.
Play Ringback Tone When selected, you will hear a ringback tone while making a call.
Blink button LED on monitor call When selected, the button LED will flash on and off during a monitor
call.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.