Product specifications

Mount the VoIP Zone Controller
Operations Guide 930446E CyberData Corporation
46
A.1.2 Mounting Procedure
To mount the VoIP Zone Controller:
1. On the mounting location, mark and then drill two 3/16-inch (0.1875-inch) holes 3.5 inches
apart from and parallel to each other for the plastic-ribbed anchors and screws. See
Figure A-1.
2. Insert the plastic-ribbed anchors into the prepared holes. See Figure A-1.
3. Install the #6 screws into the plastic-ribbed anchors and leave approximately 1/8-inch gap from
the screw head to the wall. See
Figure A-1.
4. Determine which sides of the VoIP Zone Controller will be facing up, and then slide the VoIP
Zone Controller down over the screws to latch onto the screws.
Figure A-1. Mounting