Product specifications

Implementing the VoIP V3 Zone Controller
Configuring the VoIP Zone Controller
Operations Guide 930446E CyberData Corporation
17
On the Network Setup page, enter values for the parameters indicated in Table 2-6.
On this page:
1. Specify whether you use Static or DHCP IP Addressing by marking the appropriate radio
button. Then, if you select Static, go to
Step 2.
2. For Static IP Addressing, also enter values for the following parameters:
• The VoIP Zone Controller’s IP Address: The VoIP Zone Controller is delivered with a factory
default IP address. Change the default address to the correct IP address for your system.
•The Subnet Mask.
•The Default Gateway.
3. Click Save when you are finished.
4. Click Reboot for the new settings to take effect.
Table 2-6. Network Configuration Parameters
Web Page Item Description
Stored Network Settings Shows the settings stored in non-volatile memory.
IP Addressing Select either DHCP IP Addressing or Static IP Addressing by
marking the appropriate radio button. If you select Static, configure
the remaining parameters indicated in
Table 2-6. If you select DHCP,
go to Step 3.
IP Address Enter the Static IP address.
Subnet Mask Enter the Subnet Mask address.
Default Gateway Enter the Default Gateway address.
DNS Server 1 Enter the DNS Server 1 address.
DNS Server 2 Enter the DNS Server 2 address.
Current Network Settings Shows the current network settings.
IP Address Shows the current Static IP address.
Subnet Mask Shows the current Subnet Mask address.
Default Gateway Shows the current Default Gateway address.
DNS Server 1 Shows the current DNS Server 1 address.
DNS Server 2 Shows the current DNS Server 2 address.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.