Product specifications

Implementing the VoIP V3 Zone Controller

Configuring the VoIP Zone Controller

Operations Guide 930446E CyberData Corporation

4. On the Home Page, review the setup details and navigation buttons described in Table 2-4.

At this point you can:

• Review the VoIP Zone Controller’s Current Settings. Use the RTFM switch to restore the factory

default settings. See

Section 2.3.5, "Restore the Factory Default Settings as Required".

• Configure the network parameters. Click the Networking button and refer to Section 2.4.5,

"Configure the Network Parameters" for instructions.

• Configure the SIP parameters. Click SIP Config and see Section 2.4.6, "Configure the SIP

Parameters".

• Configure the Zone parameters. Click Zone Config and see Section 2.4.9, "Configure the Zone

Parameters" for instructions.

Note Click the Upgrade Firmware button any time you need to upload new versions of the

firmware. Refer to

Section 2.5, "Upgrading the Firmware" for instructions.

Table 2-4. Home Page Overview

Web Page Item Description

Device Settings

Device Name Shows the device name (25 character limit).

Change Username Type in this field to change the username (25 character limit).

Change Password Type in this field to change the password (19 character limit).

Re-enter Password Type the password again in this field to confirm the new password

(19 character limit).

Current Settings

Serial Number Shows the device serial number.

Mac Address Shows the device Mac address.

Firmware Version Shows the current firmware version.

IP Addressing Shows the current IP addressing setting (DHCP or Static).

IP Address Shows the current IP address.

Subnet Mask Shows the current subnet mask address.

Default Gateway Shows the current default gateway address.

DNS Server 1 Shows the current DNS Server 1 address.

DNS Server 2 Shows the current DNS Server 2 address.

SIP Mode is Shows the current status of the SIP Mode.

Event Reporting is Shows the current status of the Event Reporting.

Nightring is Shows the current status of the Nightringer.

Click the Save button to save your configuration settings.

Note: You need to reboot for changes to take effect.

Click on the Reboot button to reboot the system.