Product specifications

Implementing the VoIP V3 Zone Controller

Configuring the VoIP Zone Controller

Operations Guide 930446E CyberData Corporation

2.4.3 Log in to the Configuration GUI

1. Open your browser to the VoIP Zone Controller IP address.

Note If the network does not have access to a DHCP server, the device will default to an IP

address of 10.10.10.10.

Note Make sure that the PC is on the same IP network as the VoIP Zone Controller.

Note You may also download CyberData’s VoIP Discovery Utility program which allows you to

easily find and configure the default web address of the CyberData VoIP products.

CyberData’s VoIP Discovery Utility program is available at the following website address:

http://www.cyberdata.net/support/voip/discovery_utility.html

The unit ships in DHCP mode. To get to the Home page, use the discovery utility to scan for

the device on the network and open your browser from there.

Note To work with the VoIP Zone Controller configuration after the initial configuration, log in

using the IP address you assign to the device.

Section 2.4.5, "Configure the Network

Parameters" provides instructions for entering the IP address.

2. When prompted, use the following default Username and Password to open the configuration

Home page:

Username: admin

Password: admin

Change the

Default Username

and Password

To change the default Web access Username and Password:

1. Enter the new Username from four to 25 alphanumeric characters in the Change Username

field. The Username is case-sensitive.

2. Enter the new Password from four to 20 alphanumeric characters in the Change Password field.

The Password is case-sensitive.

3. Enter the new password again in the Re-enter New Password field.

Click Save Settings.