Product specifications

Implementing the VoIP V3 Zone Controller
Setting up the VoIP Zone Controller
Operations Guide 930446E CyberData Corporation
8
2.3.5 Restore the Factory Default Settings as Required
The VoIP Zone Controller is delivered with factory set default values for the following parameters.
Use the RTFM switch (see
Figure 2-5) on the back of the unit to restore these parameters to the
factory default settings.
Figure 2-5. RTFM Switch
Note When you perform the RTFM procedure in Figure 2-5, the factory default settings are
restored. The default parameters for access are shown in Table 2-2.
To restore the VoIP Zone Controller’s factory
default settings:
1. Use a paper clip to press and hold the RTFM
switch while all of the indicator LEDs turn off.
See the picture on the right.
2. Continue to press the RTFM switch until after
the indicator LEDs turn back on.
3. Release the RTFM switch. All of the VoIP
Zone Controller settings will be restored to
the factory default settings.
4. You will hear the "Restoring defaults..." audio
message play through all ports before the
device reboots.
Back View with RTFM Switch
Paper clip RTFM switch
Table 2-2. Factory Default Settings
Parameter Factory Default Setting
IP Addressing DHCP
IP Address
a
a. Default if there is not a DHCP server present.
10.10.10.10
Web Access Username admin
Web Access Password admin
Subnet Mask
a
255.0.0.0
Default Gateway
a
10.0.0.1