Product specifications
Table Of Contents
- Contents
- 1 Product Overview
- 2 Installing the VoIP V3 Indoor Intercom
- 2.1 Parts List
- 2.2 Intercom Components
- 2.3 Intercom Setup
- 2.4 Configure the Intercom Parameters
- 2.4.1 Factory Default Settings
- 2.4.2 Intercom Web Page Navigation
- 2.4.3 Log in to the Configuration Home Page
- 2.4.4 Configure the Device
- 2.4.5 Configure the Network Parameters
- 2.4.6 Configure the SIP Parameters
- 2.4.7 Configure the Nightringer Parameters
- 2.4.8 Configure the Sensor Configuration Parameters
- 2.4.9 Configure the Multicast Parameters
- 2.4.10 Configure the Audio Configuration Parameters
- 2.4.11 Configure the Event Parameters
- 2.4.12 Configure the Autoprovisioning Parameters
- 2.5 Upgrade the Firmware and Reboot the Intercom
- 2.6 Command Interface
- Appendix A: Mounting the Indoor Intercom
- Appendix B: Setting up a TFTP Server
- Appendix C: Troubleshooting/Technical Support
- Index
Product Overview
Typical System Installation
Operations Guide 930500E CyberData Corporation
2
1.2 Typical System Installation
The Voice-over-IP (VoIP) VoIP V3 Indoor Intercom is a SIP endpoint designed to provide VoIP phone
connectivity in a tamper proof and secure package.
Figure 1-2 illustrates how the VoIP V3 Indoor Intercom can be installed as part of a VoIP phone
system.
Figure 1-2. Typical Installation—Door Entry/Access Control
Door Strike
VoIP Intercom
VoIP Intercom
IP Phone
IP PBX Server
Generic PoE Switch
12 34 56
Warning
Electrical Hazard: The VoIP Intercom enclosure is not rated for any AC
voltages.
Warning
Electrical Hazard: This product should be installed by a licensed electrician
according to all local electrical and building codes.
Warning
Electrical Hazard: To prevent injury, this apparatus must be securely attached
to the floor/wall in accordance with the installation instructions.
GENERAL ALERT
GENERAL ALERT
GENERAL ALERT