Product specifications
Table Of Contents
- Contents
- 1 Product Overview
- 2 Installing the VoIP V3 Indoor Intercom
- 2.1 Parts List
- 2.2 Intercom Components
- 2.3 Intercom Setup
- 2.4 Configure the Intercom Parameters
- 2.4.1 Factory Default Settings
- 2.4.2 Intercom Web Page Navigation
- 2.4.3 Log in to the Configuration Home Page
- 2.4.4 Configure the Device
- 2.4.5 Configure the Network Parameters
- 2.4.6 Configure the SIP Parameters
- 2.4.7 Configure the Nightringer Parameters
- 2.4.8 Configure the Sensor Configuration Parameters
- 2.4.9 Configure the Multicast Parameters
- 2.4.10 Configure the Audio Configuration Parameters
- 2.4.11 Configure the Event Parameters
- 2.4.12 Configure the Autoprovisioning Parameters
- 2.5 Upgrade the Firmware and Reboot the Intercom
- 2.6 Command Interface
- Appendix A: Mounting the Indoor Intercom
- Appendix B: Setting up a TFTP Server
- Appendix C: Troubleshooting/Technical Support
- Index
Operations Guide 930500E CyberData Corporation
58
Installing the VoIP V3 Indoor Intercom
Uploading the Firmware
2.5 Upgrade the Firmware and Reboot the Intercom
2.5.1 Uploading the Firmware
To upload the firmware from your computer:
1. Retrieve the latest Intercom firmware file from the VoIP V3 Indoor Intercom Downloads page at:
http://www.cyberdata.net/products/voip/digitalanalog/intercomindoorv3/downloads.html
2. Unzip the firmware version file. This file may contain the following:
• Firmware file
• Release notes
3. Log in to the Intercom home page as instructed in Section 2.4.3, "Log in to the Configuration
Home Page".
4. Click the Update Firmware button to open the Upgrade Firmware page. See Figure 2-28.
Caution
Equipment Hazard: V3 devices like the VoIP V3 Indoor Intercom cannot use
firmware 6.x.x or earlier, and older V1 and V2 devices cannot use firmware
7.x.x or later.
GENERAL ALERT