Product specifications
Table Of Contents
- Contents
- 1 Product Overview
- 2 Installing the VoIP V3 Indoor Intercom
- 2.1 Parts List
- 2.2 Intercom Components
- 2.3 Intercom Setup
- 2.4 Configure the Intercom Parameters
- 2.4.1 Factory Default Settings
- 2.4.2 Intercom Web Page Navigation
- 2.4.3 Log in to the Configuration Home Page
- 2.4.4 Configure the Device
- 2.4.5 Configure the Network Parameters
- 2.4.6 Configure the SIP Parameters
- 2.4.7 Configure the Nightringer Parameters
- 2.4.8 Configure the Sensor Configuration Parameters
- 2.4.9 Configure the Multicast Parameters
- 2.4.10 Configure the Audio Configuration Parameters
- 2.4.11 Configure the Event Parameters
- 2.4.12 Configure the Autoprovisioning Parameters
- 2.5 Upgrade the Firmware and Reboot the Intercom
- 2.6 Command Interface
- Appendix A: Mounting the Indoor Intercom
- Appendix B: Setting up a TFTP Server
- Appendix C: Troubleshooting/Technical Support
- Index
Operations Guide 930500E CyberData Corporation
36
Installing the VoIP V3 Indoor Intercom
Configure the Nightringer Parameters
2.4.7 Configure the Nightringer Parameters
When the Nightringer is enabled, the Intercom will register as a second SIP extension. Registration
does not have to be to the same server as the primary SIP registration. Any calls made to the
Nightringer extension will cause the Intercom to play a ring tone. There is no way to answer this call.
The Nightringer is designed to be used in buildings where calls made after hours are directed to a
ring group.
GENERAL ALERT
Nightringer requires SIP Registration. Nightringer cannot be used in peer to peer
mode.
1. Click on the Ni
ghtringer button to open the Nightringer Configuration page. See Figure 2-18.
Figure 2-18. Nightringer Configuration Setup
Caution