Product specifications
Table Of Contents
- Contents
- 1 Product Overview
- 2 Installing the VoIP V3 Indoor Intercom
- 2.1 Parts List
- 2.2 Intercom Components
- 2.3 Intercom Setup
- 2.4 Configure the Intercom Parameters
- 2.4.1 Factory Default Settings
- 2.4.2 Intercom Web Page Navigation
- 2.4.3 Log in to the Configuration Home Page
- 2.4.4 Configure the Device
- 2.4.5 Configure the Network Parameters
- 2.4.6 Configure the SIP Parameters
- 2.4.7 Configure the Nightringer Parameters
- 2.4.8 Configure the Sensor Configuration Parameters
- 2.4.9 Configure the Multicast Parameters
- 2.4.10 Configure the Audio Configuration Parameters
- 2.4.11 Configure the Event Parameters
- 2.4.12 Configure the Autoprovisioning Parameters
- 2.5 Upgrade the Firmware and Reboot the Intercom
- 2.6 Command Interface
- Appendix A: Mounting the Indoor Intercom
- Appendix B: Setting up a TFTP Server
- Appendix C: Troubleshooting/Technical Support
- Index
Operations Guide 930500E CyberData Corporation
23
Installing the VoIP V3 Indoor Intercom
Log in to the Configuration Home Page
2.4.3 Log in to the Configuration Home Page
1. Open your browser to the Intercom IP address.
Note If the network does not have access to a DHCP server, the device will default to an IP
address of 10.10.10.10.
Note Make sure that the PC is on the same IP network as the Intercom.
Note You may also download CyberData’s VoIP Discovery Utility program which allows you to
easily find and configure the default web address of the CyberData VoIP products.
CyberData’s VoIP Discovery Utility program is available at the following website address:
http://www.cyberdata.net/support/voip/discovery_utility.html
Note The Intercom ships in DHCP mode. To get to the Home page, use the discovery utility to
scan for the device on the network and open your browser from there.
2. When prompted, use the following default Web Access Username and Web Access
Password to access the Home Page (
Figure 2-13):
Web Access Username: admin
Web Access Password: admin