Product specifications
Table Of Contents
- Contents
- 1 Product Overview
- 2 Installing the VoIP V3 Indoor Intercom
- 2.1 Parts List
- 2.2 Intercom Components
- 2.3 Intercom Setup
- 2.4 Configure the Intercom Parameters
- 2.4.1 Factory Default Settings
- 2.4.2 Intercom Web Page Navigation
- 2.4.3 Log in to the Configuration Home Page
- 2.4.4 Configure the Device
- 2.4.5 Configure the Network Parameters
- 2.4.6 Configure the SIP Parameters
- 2.4.7 Configure the Nightringer Parameters
- 2.4.8 Configure the Sensor Configuration Parameters
- 2.4.9 Configure the Multicast Parameters
- 2.4.10 Configure the Audio Configuration Parameters
- 2.4.11 Configure the Event Parameters
- 2.4.12 Configure the Autoprovisioning Parameters
- 2.5 Upgrade the Firmware and Reboot the Intercom
- 2.6 Command Interface
- Appendix A: Mounting the Indoor Intercom
- Appendix B: Setting up a TFTP Server
- Appendix C: Troubleshooting/Technical Support
- Index
Operations Guide 930500E CyberData Corporation
21
Installing the VoIP V3 Indoor Intercom
Factory Default Settings
2.4 Configure the Intercom Parameters
To configure the Intercom online, use a standard web browser.
Configure each Intercom and verify its operation bef
ore you mount it. When you are ready to mount
an Intercom, refer to Appendix A, "Mounting the Indoor Intercom"for instructions.
2.4.1 Factory Default Settings
All Intercoms are initially configured with the following default IP settings:
When configuring more than one Intercom, attach the Intercoms to the network and configure one at
a
time to avoid IP address conflicts.
Parameter Factory Default Setting
IP Addressing DHCP
IP Address
a
a. Default if there is not a DHCP server present.
10.10.10.10
Web Access Username admin
Web Access Password admin
Subnet Mask
a
255.0.0.0
Default Gateway
a
10.0.0.1
Table 2-4. Factory Default Settings