Product specifications
Table Of Contents
- Contents
- 1 Product Overview
- 2 Installing the VoIP V3 Indoor Intercom
- 2.1 Parts List
- 2.2 Intercom Components
- 2.3 Intercom Setup
- 2.4 Configure the Intercom Parameters
- 2.4.1 Factory Default Settings
- 2.4.2 Intercom Web Page Navigation
- 2.4.3 Log in to the Configuration Home Page
- 2.4.4 Configure the Device
- 2.4.5 Configure the Network Parameters
- 2.4.6 Configure the SIP Parameters
- 2.4.7 Configure the Nightringer Parameters
- 2.4.8 Configure the Sensor Configuration Parameters
- 2.4.9 Configure the Multicast Parameters
- 2.4.10 Configure the Audio Configuration Parameters
- 2.4.11 Configure the Event Parameters
- 2.4.12 Configure the Autoprovisioning Parameters
- 2.5 Upgrade the Firmware and Reboot the Intercom
- 2.6 Command Interface
- Appendix A: Mounting the Indoor Intercom
- Appendix B: Setting up a TFTP Server
- Appendix C: Troubleshooting/Technical Support
- Index
Operations Guide 930500E CyberData Corporation
16
Installing the VoIP V3 Indoor Intercom
Identifying the VoIP Intercom Connectors
Figure 2-6. Connector Locations
Table 2-3. Connector Functions
Connector Function
J1 PoE Network Connection (RJ-45 ethernet)
J3 Terminal Block (see Figure 2-3)
J4 Factory Only—Console Port
J5 Factory Only—JTAG
JP1 Factory Only—Reset
JP5 Factory Only—Watch Dog
JP7 Factory Only—Boot Mode
JP10 Disables the intrusion sensor when installed.
J3
J1
JP1
JP5
J4
JP7
JP10 (2 Pin)
J5 (8 Pin)