User guide

CyberData SIP Paging Adapter Integration with MX (0000000400)

Revision 14 - August 2, 2013

Page 9 of 25

Technical Publications

6 Creating a Generic SIP Device on the MX for paging

capabilities

When using the CyberData SIP Paging Adapter for paging capabilities, Zultys recommends

creating a Generic SIP Device and a user for the CyberData Paging equipment. Only a single

device and User is required for paging purposes only, the Night Ringer will require its own user

and device. The Paging features of the CyberData Equipment interfaces with the MX system

through a preconfigured MX user. A single user / device will interface with the MX for paging

purposes. To initiate a paging message over CyberData Paging Equipment, place a call to this

user / device combination to start the paging process. This same user cannot be included in the

MX’s standard page groups. If not using SIP Paging integration, this section may be skipped.

6.1 Create Generic SIP Profile

In order to create a Generic SIP Device, it is recommended to create a unique Generic SIP

Device Profile to control the codecs, functions and number of lines used by CyberData

Equipment, this device profile should be the same profile used with the night ring device.

Make sure that the following options are selected.

Sends SIP Register:

Checked.

Supports SIP based

configuration: Checked.

Number of Lines: 1.

Supported auto-answer

type: All Calls.

Codecs: G711U and

G711A.

Send unsolicited NOTIFY

for messages: Checked.

Send Syslog event when

device is not registered..:

This is an optional selection

that is recommended to

allow the MX to generate a

syslog notification if the

paging equipment is off line

The remaining options are

unchecked.