User guide
CyberData SIP Paging Adapter Integration with MX (0000000400)
Revision 14 - August 2, 2013
© 2013 Zultys, Inc. No reproduction of distribution without permission
Page 20 of 25
Technical Publications
topsoftkey1 label : Page
topsoftkey1 type : paging
topsoftkey1 locked : 0
paging group listening : 234.2.1.1:10002
9.1.2 Example 2 (53e)
In the below example we are creating a single page zone which this phone can send pages to,
and receive pages from. The phone in this example is a 53e phone and the upper left key is the
paging key. This device will listen to 2 different paging groups as defined in the paging group
listening entry.
prgkey5 value : 234.2.1.1:10002
prgkey5 type : paging
prgkey5 locked : 0
paging group listening : 234.2.1.1:10002, 234.2.1.2:10004
9.2 Multiple Zones or Groups
If using multiple page groups or zones, for proper integration with ZIP3 devices you must assign
a unique IP address and unique port for each zone.
To configure the device to listen to multiple paging groups, add each additional unique IP and
port pair to the “page group listening :” entry separated by a comma.
10 Configuration for ZIP3 Devices
You can configure a specific key on the phone from MX Administrator that will allow you to
send or receive a page to or from pre-configured multicast address(es). The ZIP3 may listen to
up to 10 different page groups.
10.1 To Listen for Multicast paging
In MX Administrator Navigate to the ZIP3 profile and select the Advanced tab of the device
profile to enable the ZIP3xi to listen to a Multicast page. Add the following lines to the advanced
tab:
[ cfg:/phone/config/vpPhone/MulticastPage.cfg,reboot=0 ]
ListenAddress1.Label = Page_MC
ListenAddress1.IPAddress = 234.2.1.1:10002
ReceivePriority.Active = 1
ReceivePriority.Priority = 0
10.2 Configuring Page Button
In MX Administrator Navigate to the ZIP3 profile and select the Advanced tab of the device
profile to enable the ZIP3xi to make a Multicast page. Add the following lines to the Advanced
tab. In the below example, the “Page” key is the 6
th
key (or the last/bottom key).
[ cfg:/phone/config/vpPhone/vpPhone.ini,reboot=1 ]