User guide

CyberData SIP Paging Adapter Integration with MX (0000000400)

Revision 14 - August 2, 2013

Page 19 of 25

Technical Publications

9 Configuration for ZIP5 devices

An Administrator can use the following parameters in the Advanced Tab of the device profile to

create Paging Groups or Zones.

For incoming RTP multicasts, the ringing display is dependent on the “Allow Barge-In”

parameter. If this parameter is disabled, and there is no other call on the phone, then the paging

is automatically played via the preferred audio device (see the model-specific IP Phone User

Guide for setting Audio Mode on the phone).

If there is an existing call on the phone, the call initially displays in the ringing state. The user has

the option to accept/ignore the call. If the “Allow Barge-In” parameter is enabled, the RTP

multicast call barges in, and any existing calls are put on hold.

If an RTP multicast session already exists on the phone, and the phone receives another

incoming RTP multicast session, the priority is given to the first multicast session and the second

multicast session is ignored. The behavior for the incoming calls in this case is also based on the

setting for the “Allow Barge-in” parameter. The incoming call is handled as if there were an

existing call already on the phone.

9.1 Phone Configuration from the Advance Tab of the ZIP5 profile

The Key can be any programmable key on a ZIP5 including

• softkeyN type

• topsoftkeyN type

• prgkeyN type

• expmodX keyN type

• KeyN value: is the multicast IP and port you will be paging

• KeyN Label: Is the LCD label assigned to this key (if available)

• KeyN Type: is always paging

• KeyN Locked: optional, for locking changes to the key from web interface

• paging group listening: Allows you to specify up to 5 listening multicast addresses to

send/receive a Real Time Transport Protocol (RTP) stream to/from these pre-configured

multicast address(es). Each multicast IP and port combination is separated by a comma.

9.1.1 Example 1 (57i)

In the below example we are creating a single page zone which this phone can send pages to,

and receive pages from. The phone in this example is a 57i phone and the upper left key is the

paging key.

topsoftkey1 value : 234.2.1.1:10002