User guide

CyberData SIP Paging Adapter Integration with MX (0000000400)
Revision 14 - August 2, 2013
© 2013 Zultys, Inc. No reproduction of distribution without permission
Page 11 of 25
Technical Publications
Profile: Select the Generic
SIP Device Profile created in
section 6.1.
Default Location: Select the
proper location from the
drop-down.
Device ID: Type the ID to
register CyberData Paging
extension.
Contact: Not used.
SIP Proxy Password: Type
the password if required.
6.3 Create User and Assign User to the Device
After creating the device that will interface with CyberData Paging Equipment, create a user and
assign the user to this device. This document assumes the reader is a ZCSE trained and a
certified technician. Since this process is covered by ZCSE training, it is considered to be outside
the scope of this document. Note that you need to create and assign a paging profile to the user
if they will be using SIP paging.
7 MX Paging Server and User Configuration
The CyberData SIP Paging Adapter CANNOT be integrated with the MX’s Paging Server, as the
CyberData Paging Adapter requires DTMF Selection to make a Page.
8 CyberData SIP Paging Adapter Setup
When deploying the CyberData SIP Paging Adapter it is recommended to use DHCP.
CyberData provides a “Discovery Utility” that can be downloaded from their website
(http://www.cyberdata.net/support/voip/discovery_utility.html) to initially discover the IP
address of the SIP Paging Adapter, once configured to register with the Zultys MX, the IP
address can be found using the MX’s device status screen in the MXAdministrator UI. Using the
CyberData Discovery Utility to obtain the current IP address of the CyberData SIP Paging
Adapter login using a web browser using the default username of “admin” and the default of
“admin”. For more information on using the discovery utility and basic setup of the CyberData
equipment, please refer to the operating manuals from CyberData. If using the pure multicast