Product specifications

Operations Guide 930274I CyberData Corporation
Revision Information
Revision 930274I was updated on 2/3/2011 and has the following changes:
•Updates Figure 2-3, "Running the V2 Speaker with Auxiliary Power".
•Updates Figure 2-4, "V2 Speaker with Alert Strobe".
•Updates Figure 2-5, "V2 Speaker with Auxiliary Speaker Connection".
•Updates Figure 2-7, "V2 Speaker with Line Out".
•Updates Figure 2-12, "Home Page".
•Updates Figure 2-13, "Device Configuration Page".
•Updates Figure 2-14, "Network Configuration Page".
•Updates Figure 2-15, "SIP Configuration Page".
•Updates Figure 2-16, "Nightringer Configuration Setup".
•Updates Figure 2-17, "Multicast Configuration Setup".
•Updates Figure 2-18, "Audio Configuration Page".
•Updates Figure 2-19, "Audio Configuration Page (continued)".
•Updates Figure 2-20, "Audio Configuration Page (continued)".
•Updates Figure 2-26, "Event Configuration Page".
•Updates Figure 2-27, "Autoprovisioning Configuration Page".
•Updates Figure 2-28, "Firmware Upgrade Page".
•Updates Figure 2-29, "Reboot System Section".
• Updates the “Time Zone Identifier” section.
• Updates the text of the following note for Section 2.2.3.1, "Status LED":
“If the board is set to use DHCP and there is not a DHCP server available on the network, it will
try 12 times with a three second delay between tries and eventually fall back to the programmed
static IP address (by default 10.10.10.10). This process will take approximately 80 seconds.”
• Updates the text of the following note for Section 2.2.4.1, "Reset Test Function Management
(RTFM) Switch":
“Using the RTFM switch will lock the digital volume level to 4 and disable the analog volume
control dial.”