Product specifications

Installing the VoIP V2 Loudspeaker Amplifier

Configure the Loudspeaker Amplifier Parameters

Operations Guide 930360D CyberData Corporation

2.3.5.1 Point-to-Point Configuration

When the board is set to not register with a SIP server, it's possible to set the device to dial out to a

single endpoint. To do this, do the following:

1. On the SIP Configuration page (Figure 2-22), make sure that the Register with a SIP Server

parameter is not selected.

2. Type the IP address of the remote device that you want to contact into the Dial out Extension

field

Note The delayed DTMF functionality is available in the Point-to-Point Mode.

Note Establishing point-to-point SiP calls may not work with all phones.

Figure 2-22. SIP Configuration Page Set to Point-to-Point Mode

Speaker is set to NOT register with a SIP server