Product specifications

Installing the VoIP Clock Kit Wall Mount Adapter
Mounting the Clock Kit Wall Mount Adapter
Operations Guide 930283F CyberData Corporation
21
3. Make sure that the ribbon and the ethernet cable are both connected to the IP speaker assembly.
If they are not connected, then see the following sections:
• Section 2.1.2, "Moving the Clock Connector Cover Plate"
• Section 2.1.3, "Connecting the Clock to the Speaker"
• Section 2.1.4, "Connecting Power to the Speaker"
Note You can route the Ethernet cable through the back or through the slots at the top or bottom
of the wall mount adapter.
4. Position the IP speaker assembly into the clock kit wall mount adapter so that the IP speaker
assembly screw holes align with the mounting holes in the clock kit wall mount adapter.
● Use three 8-32 x 1 1/4” mounting screws (from the Ceiling Speaker Drop Ceiling Mounting Kit)
to secure the IP speaker assembly to the wall mount adapter.
2.4.3 Uploading the Firmware
Depending on which speaker you are using, please see one of the following documents:
● VoIP V2 Speaker Operation Guide
● VoIP V2 Talkback Speaker Operation Guide
These documents are available at the following website address:
http://www.cyberdata.net/products/voip/digitalanalog/clockkit/docs.html
2.4.4 Setting the Time on the Clock Kit Adapter
Depending on which speaker you are using, please see one of the following documents:
● VoIP V2 Speaker Operation Guide
● VoIP V2 Talkback Speaker Operation Guide
These documents are available at the following website address:
http://www.cyberdata.net/products/voip/digitalanalog/clockkit/docs.html
2.4.5 Confirm that the Speaker is Operational and Linked to the Network
Depending on which speaker you are using, please see one of the following documents:
● VoIP V2 Speaker Operation Guide
● VoIP V2 Talkback Speaker Operation Guide
These documents are available at the following website address:
http://www.cyberdata.net/products/voip/digitalanalog/clockkit/docs.html